Catasetum Seedling Mold
Hello All,
Been lurking in these message boards for awhile now. First post.... Looking for some guidance. I recently purchased my first flask. Ctsm hyrbid. When I planted them I had rehydrated the spagh I used in a physan solution as well soaking the plants in the same solution. I have the plug tray in a humidity dome on top of a heating mat to maintain temp between 69-74 degrees Fahrenheit. Planted 6 days ago. This morning I noticed mold on a couple of the surfaces of the spagh. Removed them from the tray. Sprayed the remaining with a physan solution. My question is what should my next steps be? Is this going to be salvageable? If so, what would your advice be to prevent future molding?
|
Threaded Mode
