Orchid Board - Most Complete Orchid Forum on the web !

Orchid Board - Most Complete Orchid Forum on the web ! (http://www.orchidboard.com/community/)
-   Beginner Discussion (http://www.orchidboard.com/community/beginner-discussion/)
-   -   getting rid of algae growth on inside of greenhouse (http://www.orchidboard.com/community/beginner-discussion/87657-getting-rid-algae-growth-inside-greenhouse.html)

iamppdoc 10-29-2015 12:27 PM

getting rid of algae growth on inside of greenhouse
 
I have developed algae on the inside of the glass of my greenhouse. Besides being ugly, it is cutting down some on the light. Any suggestions about how to clean it off and keep it off?
Thanks
Ed

Brooke 10-29-2015 03:17 PM

I use bleach water to remove it. I've tried Physan at the recommended dosage and it doesn't budge it. I use a long handled squeegie type thing and scrub it down. I wet the surface with water, then apply the bleach water and then rinse it off.

The covering over the sponge is nylon because I don't want to scratch the polycarb. If you have glass, it isn't as susceptible to scratching as the polycarb.

Brooke

bil 10-29-2015 03:23 PM

Quote:

Originally Posted by Brooke (Post 778027)
I use bleach water to remove it. I've tried Physan at the recommended dosage and it doesn't budge it. I use a long handled squeegie type thing and scrub it down. I wet the surface with water, then apply the bleach water and then rinse it off.

The covering over the sponge is nylon because I don't want to scratch the polycarb. If you have glass, it isn't as susceptible to scratching as the polycarb.

Brooke

Ahhh... be careful! Those scourers can scratch glass and even stainless steel!

Ray said that since he has been using a lower strength fetiliser, his algae problem has disappeared.

Brooke 10-29-2015 04:28 PM

Sorry my fertilizer is not applied to the g/h walls. Over spray of rain water is all it gets.

The covering over the sponge is not a scourer, it is nylon net - very soft.

Brooke

Ray 10-29-2015 06:39 PM

Fertilizer doesn't get on my greenhouse walls either, but since switching to a low-phosphorus fertilizer and reducing the concentration applied to the plants, the overall supply of algae has dropped, and I don't get growth on the glazing any longer.

No matter what you use to kill the algae on the glazing, get it and the residue off immediately, or you may end up with a white, very-difficult-to-remove "crud" left behind.

bil 10-30-2015 11:13 AM

Quote:

Originally Posted by Ray (Post 778060)
Fertilizer doesn't get on my greenhouse walls either, but since switching to a low-phosphorus fertilizer and reducing the concentration applied to the plants, the overall supply of algae has dropped, and I don't get growth on the glazing any longer.

No matter what you use to kill the algae on the glazing, get it and the residue off immediately, or you may end up with a white, very-difficult-to-remove "crud" left behind.

Ray, I don't know, but I suspect that might be a calcium carbonate compound the alga uses to glue itself to the surface.

Did you try an acid based cleaner?


All times are GMT -4. The time now is 04:17 AM.

3.8.9
Search Engine Optimisation provided by DragonByte SEO v2.0.37 (Lite) - vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.


Clubs vBulletin Plugins by Drive Thru Online, Inc.