If this belongs somewhere else, feel free to move this
Wow, I thought my first setup was cool until I saw all of the others...
Well mine may not be pretty, but it is pretty practical...
I think?....
Setup so far:
Connectable wire shelving
outside measurements 31" long, 15.5" wide, 42"-43" height
Plastic covering with dual zippers on both sides in front.
Attachable shelving that can be placed at different heights.
Mini fan
Humidifier (eventually need smaller one)
Humidity gauge/ thermometer.
*Needing a better heat and light source in future
I was aiming for a cheap setup, well that didn't happen exactly. I worked with what the tabletop permitted.
I can move the fan around and also remove the big humidifier (goes from 40 to 70 in 3 minutes), also the temperature increases from 3ºF - 20ºF.
At night the lowest has been 59ºF, but not usually lower than 66ºF with the completion of the plastic covering.
With the warm mist humidifier, the highest temps reach 88ºF.
The covering helps the humidity stay higher for longer, but eventually matches the house's 30-40 again.
I obviously cannot leaving the humidifier running more than 10 minutes either, unless I figure out the right amount of opening.
All in all it may not fit more than 10
if I'm lucky but it is a start!
This was also my first completed sewing project! AND ALL BY HAND! So I did get something out that's not so obvious, some new skills
My poor lonely Phal.. with the dying flowers
Sorry about the foggy photos, I had just ran the humidifier. Also, Once I get that area cleaned up I will be able to present better photos.
I know it may not seem like it, but this setup looks better in person than my crappy photos.
My Tabletop Setup
Threaded Mode
