Here are some measurements which I have accumulated.
A bit difficult to see, but OB doesn't seem to support "table" bbcode.
watt: measured by kill-a-watt
micromol/m^2/s: PPFD measured at 12" distance. I used old, uncalibrated Li-Cor LI-190
fc: footcandles at 12" measured by cheap LX1330B.
PPFD/fc: conversion between PPFD and foot-candle
For the A-type bulbs, I used cheap clip-on reflector (small one, around 6" diameter).
The ones with ** at the end are used bulbs, and others are the measurement from fresh bulbs.
Note that the narrow beam pattern like Cree PAR38 will give high values of PPFD, fc and PPFD/watt because I'm not integrating over the entire area. But PPFD/fc is better with LED than CFL (so ones need to be careful with that kind of comparison with light meter).