Quote:
Originally Posted by Eyebabe
I don't grow cymbidiums either but have killed two
The leaves should not be dying off so fast; I would be concerned about the roots.
The brown spots look fungal to me...
|
Hmm... I looked at the link in the "Pests & Diseases" section. I have some of those and I have new photos that I'm not sure about.
1. Center Yellowing with Green Sides: Just like the last photo under Bacterial Soft & Brown Rot (Erwinia) in that link. I am pretty sure I caused this when I mist in the morning. I noticed a while back that the bulbs looked shriveled and leaves starting to crinkle. I was afraid of overwatering and thought
misting would be enough until I had more time on the weekends to water. To treat, it says to remove the infected leaf and to spray with bactericide like Physan. Would I have to worry about the same problem if I spray again even with Physan or is it ok?
2. Brown spot: Not sure what that is.
3. Black Spot on Yellowing Leaf: On a different cymbidium, I noticed 2 of these spots on tip of one leaf. It looks just like the 3rd photo under Bacterial Brown spot. I increased air flow with a tiny fan I put by the windowsill for increased air movement. I removed that section and hope it will be enough.
4. Black line going down middle of leaf: No idea what this is. Will it gradually turn into #1?
5. Yellow Leaf on New Growth: This is a close-up of the new growth that's turned yellow. My guess is this is what #1 looks like if left unchecked.
6. 3 Yellow Spots: Looks similar to the photo of Septoria symptoms. There are tiny black dots on the other side. It didn't show in the photo. Can be solved with reducing wetness on leaves and alternating between systemic & protectant fungicide.
Seems that all this has probably been a result of
misting in the morning. I will stop
misting, especially since I'm causing more harm than good. Can anyone give any recommendations on treatment? The website says to spray but when I read the Physan packet, it says to "remove compost from plant, then soak entire plant 10 minutes or more. Cut away all rot with treated tool. Repot in physan soaked compost. Use: 1 tablespoon physan 20 per gallon of water."
I am hesitant in unpotting it for several reasons:
a) It's in a 7" pot and very tightly packed. I have never dealt with a plant of this scale.
b) It normally blooms in August (according to seller) and do not see any active growth right now. It was recommended that I repot in September if I did not see any blooms as that is the start of the growth period.
c) I was going to attempt my 1st division to make it into a more manageable size.
Can I just spray it at the recommended dilution and hope for the best? How often should I keep up the treatment?
Additionally, I am new to growing plants in general (not just orchids) and am not having a good success rate. I just watched 2 phals die and a dendrobium just bit the dust today. My other orchids are just repotted in bark now after suffering root rot with few roots left. At this point, I'm not even hoping for blooms. I'm just hoping they'll survive. I have a couple of orchids books that I refer to for reference, but not a lot of pictures, which leads me here to ask for help in identifying problems. It seems that no matter how much I try to care for them, I wind up doing more harm than good. Sorry for the long post and my ranting. I just feel it's a matter of time before I manage to kill off the rest of my orchids.
|
|
|
|
Mistking
|
Looking for a misting system? Look no further. Automated misting systems from MistKing are used by multitude of plant enthusiasts and are perfect for Orchids. Systems feature run dry pumps, ZipDrip valve, adjustable black nozzles, per second control! Automatically mist one growing shelf or a greenhouse full of Orchids. See MistKing testimonials |
|
|
|
|
|